DAX or TCI¶
RimuDAX connects your digital-mode, logging and skimmer programs to the radio in one of two ways. On Linux, you choose either one. On Windows, TCI is the only one.
- DAX
- Sound devices. Your program selects the RimuDAX devices as its soundcard. Frequency, mode and keying use a separate CAT connection, usually through RimuCAT.
- TCI
- A network connection. Your program connects to RimuDAX at an address and a port. One connection carries the audio, frequency, mode and transmit control.
| Linux | Windows | |
|---|---|---|
| DAX | Click DAX in the Mode row | Not available |
| TCI | Click TCI in the Mode row | Always on. There is no Mode row. |
Which one to use¶
- On Windows
- Use TCI. There is no choice to make.
- On Linux
- Use the one that suits you. DAX works with any program that can select a sound device. TCI needs a program that supports it, and then needs no audio devices and no CAT port.
On Linux, RimuDAX starts in the mode you last used. The first time it runs, it starts in DAX mode.
On Windows, your program must support TCI¶
RimuDAX for Windows has no DAX sound devices, and will not have them. If a program does not support TCI, RimuDAX cannot carry its audio on Windows. Check the program's documentation for TCI support, or look for a newer version.
A program that needs frequency and mode but no audio, such as a logger, can use RimuCAT instead.
What you do not need with TCI¶
A program that uses TCI does not need any of these:
- A virtual audio cable or other sound driver.
- A virtual COM port tool.
- Flex DAX drivers.
- A RimuCAT port.
RimuDAX on Windows creates no sound devices and no COM ports. Do not look for them in your program's settings. Look for a TCI setting instead.
Why "DAX channel" still matters with TCI¶
You still set a DAX channel on the slice in RimuSDR when you use TCI. Here, the number only selects the slice. It decides which TCI port reaches that slice. See Ports.
Programs with results on record¶
| Program | Tested on | What was tested |
|---|---|---|
| WSJT-X | Linux | FT8 contacts |
| WSJT-X Improved | Windows | FT8 contacts |
| MSHV | Windows | Frequency, mode and FT8 decoding |
| Log4OM | Windows | Frequency, mode, spots, spot clicks and CW macros |
| SDC | Windows and Linux | CW decoding from the IQ stream |
| DXLog | Not tested | Settings read from the program only |
Other programs that support TCI can also connect. This table lists only the programs that we have results for.
Next steps¶
- To use TCI, on Windows or Linux, go to Using TCI.
- To use DAX, on Linux, go to Connecting RimuDAX.