Skip to content

Radio Setup - NTP, APD, PTT Override and MTU

This page covers the parts of the Radio Setup dialog that RimuSDR 1.1.17 adds or changes: the NTP and APD tabs, PTT Override on the Phone/CW tab, the MTU on the Network tab, and View Unlocked Features on the Radio tab. The Audio and External tabs have their own pages: Radio Setup - Audio Settings and Radio Setup - External.

Go to Settings › Radio Setup... and choose the tab.

NTP tab

The NTP tab lists, adds, edits and removes the time sources that the radio uses to set its clock. The tab is shown only for radios that support NTP time sources.

The NTP Time Sources table has these columns: On, Name, Address, Type, Prefer, Status and Description. Click the On or Prefer check box to change it. Click a source to see its State, Stratum and Reachability under Selected source.

Add a source

  1. Click Add....
  2. In Name, type 1 to 64 letters, digits or hyphens. The name cannot start or end with a hyphen, and must not be in use on the radio.
  3. In Address, type the server address, 1 to 253 characters.
  4. In Type, choose server, pool or peer.
  5. Optionally, type a Description of at most 62 characters.
  6. Optionally, tick Prefer this source.
  7. Click OK.

The radio holds at most 10 sources.

Edit or remove a source

To edit a source, select it and click Edit..., or double-click it. You cannot change the name of a source.

To remove a source, select it and click Remove, then confirm.

Keep one source enabled

If you remove the only enabled source, the radio clock free-runs until you add a source or enable one again.

When no sources are configured, the radio creates default-pool again at its next restart.

APD tab

The APD tab sets the external sampler port for each TX antenna. Use it to set up External APD with an amplifier from RimuSDR. The tab is shown only for radios that report configurable APD, such as the FLEX-8000 series and Aurora.

External Sampler (per TX ANT)
A drop-down for each TX antenna: ANT1, ANT2, XVTA and XVTB. Each one lists the sampler ports that the radio offers for that antenna. XVTB is shown only on models that allow diversity.
Equalizer Reset
Reset resets the APD equalizer.

PTT Override (Phone/CW tab)

PTT Override is in the Microphone group of the Phone/CW tab. When it is on, a footswitch or other hardware PTT (RCA, ACC or the mic's PTT) transmits the microphone even when DAX or remote audio is the selected source. When it is off, hardware PTT uses the selected source, as MOX does. The setting applies to the whole radio.

PTT Override needs radio firmware 4.3 or later. On older firmware, the button is grayed out. It is off by default on firmware 4.3.

MTU (Network tab)

MTU on the Network tab sets the network MTU, from 900 to 1500 bytes. The default is 1450. RimuSDR saves the value and sends it on every connect, whichever radio you connect to.

Over SmartLink, the Network tab shows only the MTU setting.

View Unlocked Features (Radio tab)

View Unlocked Features, in the License Info group of the Radio tab, lists two groups of features:

Yours forever
The features that stay unlocked on your radio, for example after a SmartSDR+ subscription ends.
Included in SmartSDR
The features included in your SmartSDR version.

The button is available when the radio has reported its license.